|  Home  |  Who Am I?  |  The Sonex  |  Build Diary  |  Contact Me  | 


Build Diary

Aero Conversions Trim System

 



The Aero Coversions trim system needs a bit of work, as the instructions are not quite correct. They tell you to make a support plate and rivet it to the rear cross tie, but there is no space to do this as the rear spar carry through gets in the way. I made my own plate and mounted it forward of the rear spar carry through. The instructions also show the cable guide going through one of the under seat angles - however for the lowered seat guys, this will cause some hang-up of the spring. I made my own plate and situated it just to the right of where the instructions tell you to - thus creating a bit of space between the spring and the seatbelt bracket. The photos show you what I mean.

 
previous | next 

 

Disclaimer

Be advised that this site IS NOT an official or approved site of Sonex LLC and is in no way intended to be a publication of Sonex LLC. These pages may contain ideas, opinions, and methods employed by me in the construction of my personal aircraft. They are not necessarily the most desirable method nor are they necessarily endorsed, approved or recommended by Sonex LLC. Many of the ideas and methods which may be discussed in the site represent a compilation of ideas and methods which other builders have used or expressed on other web sites and in separate correspondences. The photos, tips, if any, and methods presented on this site are provided only as this builder’s construction process, for information as a forum for exchange and the sharing of ideas and construction methods. NO responsibility or liability is assumed, expressed, or implied as to the suitability, accuracy, safety, or approval by me or any agency thereof. Any person using any suggestion, idea, method, example or material depicted on these pages, does so at his/her own risk and discretion and without recourse against the site owner or any other person and/or agency noted on this site.